Last week Grizzly Equipment Repair performed an
engine inflame - rebuilding the engine still in the
truck - on a International DT466E. The engine was
torn down with the cylinder head sent out to get
pressure tested and machined. The picture on the
right is of the block after being cleaned. New main
bearings where "rolled" into the block for the
crankshaft. New cylinder liners where installed into the cylinder block and then
new piston crowns where installed onto the connecting rods. The rings where then installed and using a ring compressor the pistons where install into the new liners of the DT466. The picture below shows the block with pistons in and the head gasket in place just waiting for the rebuilt cylinder head to added.
engine inflame - rebuilding the engine still in the
truck - on a International DT466E. The engine was
torn down with the cylinder head sent out to get
pressure tested and machined. The picture on the
right is of the block after being cleaned. New main
bearings where "rolled" into the block for the
crankshaft. New cylinder liners where installed into the cylinder block and then
new piston crowns where installed onto the connecting rods. The rings where then installed and using a ring compressor the pistons where install into the new liners of the DT466. The picture below shows the block with pistons in and the head gasket in place just waiting for the rebuilt cylinder head to added.